magnetic separator machine

The basic structure of the magnetic separation machine, the wet permanent magnet cylinder type PTMS MAGNETIC SEPARATOR is mainly composed of cylinder, roller, brush roller, magnetic system, groove body, transmission part 6 parts. The cylinder is welded by 2-3mm stainless steel plate coil, and the end cover is cast aluminum piece or workpiece, connected with stainless steel screws and cylinder. The motor through the reducer or directly with the infinite speed control motor, drive the cylinder, magnetic roll and brush roll for rotary movement.

PTMS Electromagnetic Separator

The magnetic system is an open magnetic system, installed in a PTMS MAGNETIC SEPARATOR cylinder and exposed full magnetism. The magnetic block is installed on the bottom plate of the magnetic yoke with stainless steel bolt, the shaft of the magnetic yoke is extended out of the cylinder, and the shaft end is fixed with a turning arm. Turning the turning arm can adjust the bias Angle of the magnetic system, and it can be fixed with a pull rod after adjusting properly. The working area of the tank body is made of stainless steel plate, and the frame and other parts of the tank body are welded with ordinary steel.

what is magnetic separation process ？

PTMS MAGNETIC SEPARATOR Working principle, after the pulp flows into the tank through the ore tank, under the action of the water flow of the ore water spray pipe, the ore particles enter the tank mining area in a loose state. Under the action of the magnetic field, the magnetic mineral particles occur magnetically poly to form a "magnetic mass" or "magnetic chain", "magnetic mass" or "magnetic chain" in the pulp by magnetic force, to the magnetic pole movement, and is adsorbed on the cylinder.

Contact: DELLA

Mob: +86-13929907491

sales@powtechina.com