Magnetic separator manufacturer

By simulating the actual working environment of PTMS magnetic separation, the performance of the repaired parts was tested, and their performance in the condition of pulp scouring, magnetic particle adsorption was observed, so as to judge whether they really recovered to a state close to the original performance. The outer ring wear of magnetic separation equipment is a complex process and is affected by many factors.

PTMS Electromagnetic Separator

The friction of the magnetic particles in the pulp and the outer ring is a direct cause of the wear of the outer ring. During the work of PTMS magnetic separation, the pulp contains a large number of magnetic particles. These magnetic particles are adsorbed to the outer ring surface due to the magnetic field. When the rotating ring parts of the magnetic separator begin to rotate, these magnetic particles adsorbed on the surface of the outer ring will produce a relative sliding with the movement of the outer ring.

what is magnetic separation in Feldspar？

This relative sliding is like a tiny sandpaper constantly polishing the surface of the outer ring, continuously cutting the material of the outer ring. Moreover, with the PTMS magnetic separation running for a long time, this friction will become more and more obvious, just like water dripping through a stone, gradually causing severe wear on the outer ring.

Contact: DELLA

Mob: +86-13929907491

sales@powtechina.com