drum separator

After the installation of the permanent magnet rod, connect the rotating shaft through the hole through the top cover of the PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC with the motor, put the mixing device into the mixing tank, and lock and seal it. Docking the slurry pipe with the feeding pipe, dock the discharging pipe with the slurry outlet pipe, and open the valves on the feeding pipe and discharging pipe.

PTMS Electromagnetic Separator

Open the stirring tank, the stirring frequency is 10 hz, the slurry enters from the feeding pipe through the screw pump, and the feeding speed of the screw pump is 0.6. When the permanent magnet rod PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC rotates in the stirring tank, and then filling the mixing tank, the slurry overflows from the top, and flows out along the discharge pipe. After discharging, close the valve on the feeding pipe and discharging pipe, and remove the pipe.

what is magnetic separation？

After the slurry is discharged, remove the PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC pre-mixing device and motor and transfer it to the cleaning room; rinse and dry the outer end of the permanent magnet rod with the slurry solvent, remove the permanent magnet rod from the top to the bottom and put the stirring device into the holder; clean the mixing holder with the slurry solvent, dry and store it for next use.

Contact: DELLA

Mob: +86-13929907491

sales@powtechina.com