magnetic equipment

Lubrication and replacement of dry PTMS MAGNETIC SEPARATOR bearings. Clean dry shall be cleaned after 300 hours. If the bearing is oil lubrication, it is advisable to fill the gap of the bearing seat, no more than 1 / 2. However, only tighten the regular oil cup cover a little before operation.

PTMS Electromagnetic Separator

When dry PTMS MAGNETIC SEPARATOR bearings are seriously worn or damaged, they should be replaced in time and pay attention to strengthen lubrication; when using conical roller bearings, check the bearing axial interval to keep it at 0.2-0.4 mm. In case of discomfort, it can be adjusted by adding or adding the paper pad at the bearing cover. Repair and replacement of the dry magnetic separator screen net. The screen is made of thin steel sheet or iron sheet punch.

what is magnetic separation method ?

When the screen is worn or broken down by a foreign body, if the damage area is not large, it can be repaired by riveting or tin welding; if a large area is damaged, a new sieve should be replaced. When installing the PTMS MAGNETIC SEPARATOR screen, the side of the sieve with burr should be facing in, smooth and outward, and the sieve and sieve frame should be tightly fitted. When the ring sieve sieve piece is installed, the lap layer stubble should be in the rotation direction to prevent the material from sticking at the lap place.

Contact: DELLA

Mob: +86-13929907491

sales@powtechina.com