Graphite iron

Some three-component material suppliers are limited by plant design or cost pressure, the equipment automation is not high, the manufacturing process break point is long, it is necessary to strictly control the powder exposure time, the powder in the transit process is best to use nitrogen filled barrels. PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC removal effect is good.

PTMS MAGNETIC SEPARATOR

Temperature and humidity of PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC production workshop is also a key control index, theoretically speaking, the lower the dew point is the more favorable. Most ternary material suppliers will focus on the moisture control after the sintering process. They believe that the sintering temperature of about 1000 degrees can remove most of the moisture in the powder. As long as the water introduction from the sintering process to the packaging stage is strictly controlled, the moisture of the material can be basically guaranteed not to exceed the standard.

what is magnetic separation？

Of course, this does not mean that there is no need to control water before sintering process, because if too much water is introduced into the previous process, the sintering efficiency and the microstructure of PTMS LITHIUM COBALT ACID MATERIAL MAGNETIC removal will be affected. In addition, the way of packaging is also very important, most of the material suppliers use aluminum bag vacuuming packaging, it seems that this way is the most economical and effective.

Contact: DELLA

Mob: +86-13929907491

sales@powtechina.com