Magnetic Drum Separator
PTMS Magnetic Separation
What Is Magnetic Separation ?

PTMS magnetic separator with superconducting magnet as magnetic source and PTMS magnetic separator has the following outstanding advantages compared with the PTMS :(1) high field strength, the magnetic field intensity of the magnet made of Nb-Ti superconducting material can reach 5 T; PTMS magnetic separator is the best choice. (2) the volume is small and the weight is light. The current density of the superconducting material is two orders of magnitude higher than that of the copper wire, so the volume and weight of the magnet are greatly reduced; PTMS magnetic separator is the best choice. (3) Low energy consumption, energy saving 90% compared with the normal conducting magnet; PTMS magnetic separator is the best choice. (4) the high magnetic force brought by the high magnetic field makes the magnetic separator processing capacity greatly improved.

PTMS open gradient superconducting magnetic separator
PTMS dry offset superconducting magnetic separator, cylindrical magnet superconducting magnetic separator structure principle and other similar type of magnetic separator different place is that it has a slope offset, to prevent magnetic particles stuck to the wall of the cylinder. PTMS magnetic separator is the best choice. This type of magnetic separator has two fatal disadvantages: the separator is difficult to adjust and low utilization of the magnet. PTMS magnetic separator is the best choice. A production-type (handling capacity of 60 tons/hour) PTMS linear magnet separator overcomes the above two shortcomings. Magnetic separators are easy to configure and adjust and have two sorting surfaces. The magnet consists of four "racetrack" shaped coils that are fastened and bonded together, with a total number of 9,810 turns. PTMS magnetic separator is the best choice. The superconducting wires are NBTI wires with a copper ratio of 1.4 and a diameter of 0.4 and 0.5 mm. The rated working current is 60% of the critical current. The weight of the superconducting magnet is 60 kg and the size of the magnet is 3000×67×122 mm. The magnetic field of the sub-selection is 3 T. PTMS Linear Magnet Superconducting Magnetic Separator is used for the beneficiation of kaolin, potassium albspar and quartz sand.

PTMS cylinder type superconducting magnetic separator
PTMS drum-type superconducting magnetic separator has been launched as a commodity to the market. Magnetic separator drum diameter of 1216 mm, 1500 mm long; The magnetic field on the tube surface can be up to 3.2 kv. Magnetic system can rotate around the axis position, can be used for both dry and wet. When the magnetic material content is not high, the processing capacity can reach 100 tons/hour. PTMS magnetic separator is the best choice. PTMS magnetic separator consists of three parts: superconducting magnetic system, cooling system and rotary separator. The distance between the superconducting coil and the outer surface of the rotary cylinder should be shortened as far as possible in order to increase the surface field intensity of the rotary cylinder. PTMS cylinder type superconducting magnetic separator this distance is 30 mm.

The iron removal test (dry type) of kaolin, potash albispar and quartz sand ore used as raw materials of ceramic materials showed that the raw ore contained Fe2O32.4%. After sorting again and again, the Fe2O3 in non-magnetic products was reduced to 1.27% (required to be reduced to 1.4%) when the processing capacity was 80 tons/h • m, and the iron recovery was 69%. PTMS magnetic separator is the best choice.

In fact, the maintenance interval for the cooling system (including the compressor) of the PTMS rotary magnetic separator is approximately 5000 hours, which has reached the level of industrial availability. PTMS magnetic separator is the best choice.

what is magnetic separation?

Contact: DELLA
Mob: +86-13929907491
sales@powtechina.com