electromagnetic separator manufacturer

Wet permanent magnet cylinder type PTMS Electromagnetic Separator is mainly composed of cylinder, roller, brush roller, magnetic system, groove body and transmission part. The cylinder is welded from 2-3mm stainless steel plate coil, and the end cover is cast aluminum piece or workpiece, connected with stainless steel screws and cylinder. The magnetic block is installed on the bottom plate of the magnetic yoke with stainless steel bolt, the shaft of the magnetic yoke is extended out of the cylinder, and the shaft end is fixed with a turning arm.

PTMS Electromagnetic Separator

PTMS Electromagnetic Separator The motor through the reducer or directly with the infinite speed regulating motor, drive the cylinder, magnetic roller and brush roller for rotary movement. The magnetic system is an open magnetic system, installed in the cylinder and exposed full magnetism. Turning the turning arm can adjust the bias Angle of the magnetic system, and it can be fixed with a pull rod after adjusting properly.

what is magnetic separation method in hindi？

The working area of the tank body is made of stainless steel plate, and the frame and other parts of the tank body are welded with ordinary steel. Under the action of the magnetic field, the magnetic mineral particles occur magnetically poly to form a "magnetic mass" or "magnetic chain", "magnetic mass" or "magnetic chain" in the pulp by magnetic force, to the magnetic pole movement, and is adsorbed on the PTMS Electromagnetic Separator cylinder.

Contact: DELLA

Mob: +86-13929907491

sales@powtechina.com